I've successfully replaced the Analog functions in Marlin's temperature.cpp, with calls to Pedro Villanueva's ADC library for the Teensy 3.1, and am getting good temperature readings out of it.
Now on to updating the PID functions for the heaters...
This is looking quite doable my friends!
My Previous blogs on this project:
(little did I know I'd be working on this on and off for a year... and the real work is just beginning)
Here's a couple shots from Repetier Host.
Now on to updating the PID functions for the heaters...
This is looking quite doable my friends!
My Previous blogs on this project:
(little did I know I'd be working on this on and off for a year... and the real work is just beginning)
- You have to see this Rich ADC library for Teensy 3.1 !!!
- Marlin Firmware Compiled on Teensy 3.1 and ... well..
- Repscrap: DC Motor Control for X-Y working - now to Teacup_Firmware
- Teensy 3.1 based Repstrap control board initial wiring completed - test #1
- Prototype Printer Controller Cont'd - Teensy 3.1 w/DC motor/encoders
- Prototype Board: DC motor/Encoder - Teensy 3.1 based 3D printer controller
- Teensy 3.1 Repstrap printer with DC motor control and Flex Timer Quadrature Encoders
- Developing a Robot Shield for Teensy 3.1: Looking for feedback
- Using the Arduino PID Library for position control of X and Y axis on RepScrap printer
- Further Progress on framing my RepScrap 3D printer.
- My Repscrap: DC motors and rotary encoders for Z-Axis too?
- Arduino Sketch to manage high resolution - high speed linear encoders
- Followup on 3D printer from Scavenged DC Motor / Encoders Blog
- Using DC Motors and Encoders for 3D printer: Challenging the norm!
- My journey into building a 3d printer from old printer parts